What is Flexible Self-Adhesive Stainless steel Flat trim

• Apply clean metal lines at the end of a project without mixing mortars or scheduling a return visit.
• Ideal over delicate substrates (tile glaze, glass, finished wood, lacquered panels).
• Defines joints between materials (tile ↔ paint, microcement ↔ stone, wood ↔ vinyl).
• Shields vulnerable tile or panel edges from chipping.
• Delivers uniform, high-contrast or color-matched lines for modern interiors.

• Backsplash terminations, vanity edges, shower niches (out of direct water jet).
• distinctive lines on walls, niches, display installations, shelves, etc.
• Visual separators between tile/stone/wood/vinyl (on smooth, prepped substrates).
• Cabinet reveals, door skins, panel joints, and custom displays.
• Signage & fit-outs: Temporary/permanent brand elements where a precise metal line is needed.

hand-formable to gentle curves (e.g., large-radius arcs on walls, columns, counters). They won't wrap tight radii like a soft plastic, but they'll follow in real-world substrates-without kinking when handled correctly.

• Generally, it is 201 stainless steel coil. If you need to customize 201 or 316, it can be customized
• It adopts a high-adhesion PSA backing. Just tear off the backing sticker and it can be pasted and installed.

• Peel-stick-no thinset, clamps, or cure times.
• Ideal for last-minute detailing and punch-list fixes.
• No drilling into tile glaze or finished joinery.
• Ultra-slim, consistent reveals; premium stainless finish.
• Works on walls, furniture, and some floors (light traffic), not just tile edges.

• flat, clean, dry, dust-free surfaces.
• Continuous direct water jets or immersion can challenge the bond-use mechanical trims or sealants in those zones.
• High-impact floors: profiles.
• For small radii or compound curves, consider flexible PVC/aluminum profiles designed for that purpose.

1. Plan the lines: Use a laser or tape to draw your lines.
2. Surface preparation: Degreasing with isopropyl alcohol; Ensure the surface is smooth, dust-free and fully cured.
3. Heating the room: 18-30℃ can improve initial stickiness (avoid cold/damp environments).
4. Peeling and placement: Remove a small section of the lining, align it with the starting point, and then peel gradually along the length.
5. Rolling in: Apply uniform pressure using a rubber roller or soft block, including the edges and ends.
6. Facial protection: Keep the facial protective film on until final cleansing. Avoid using rough abrasives.

• (304/316, brushed lines, PVD color stability)
• (width/thickness/length, custom die-cut corners)
• (roll-outs, multi-site programs, sample support)